Previously, the global configuration section was required for NF to start,
which differed from earlier versions where it was optional. This commit modifies
the implementation to make the global section optional again,
allowing NF to start without explicitly defining global settings.
This change restores the previous behavior and improves usability for users
who do not need to customize global settings.
Because a race condition can occur between S6A Diameter and S1AP message,
the following error handling code has been added.
1. InitialUEMessage + Attach Request + PDN Connectivity request
2. Authentication-Information-Request/Authentication-Information-Answer
3. Authentication Request/Response
4. Security-mode command/complete
5. Update-Location-Request/Update-Location-Answer
6. Detach request/accept
In the ULR/ULA process in step 6, the PDN Connectivity request is
pushed to the queue as an ESM_MESSAGE because the NAS-Type is still
an Attach Request.
See the code below in 'mme-s6a-handler.c' for where the queue is pushed.
if (mme_ue->nas_eps.type == MME_EPS_TYPE_ATTACH_REQUEST) {
rv = nas_eps_send_emm_to_esm(mme_ue,
&mme_ue->pdn_connectivity_request);
if (rv != OGS_OK) {
ogs_error("nas_eps_send_emm_to_esm() failed");
return OGS_NAS_EMM_CAUSE_PROTOCOL_ERROR_UNSPECIFIED;
}
} else if (mme_ue->nas_eps.type == MME_EPS_TYPE_TAU_REQUEST) {
r = nas_eps_send_tau_accept(mme_ue,
S1AP_ProcedureCode_id_InitialContextSetup);
ogs_expect(r == OGS_OK);
ogs_assert(r != OGS_ERROR);
} else {
ogs_error("Invalid Type[%d]", mme_ue->nas_eps.type);
return OGS_NAS_EMM_CAUSE_PROTOCOL_ERROR_UNSPECIFIED;
}
If you perform step 7 Detach request/accept here,
the NAS-Type becomes Detach Request and the EMM state changes
to emm_state_de_registered().
Since the PDN, which is an ESM message that was previously queued,
should not be processed in de_registered, the message is ignored
through error handling below.
Otherwise, MME will crash because there is no active bearer
in the initial_context_setup_request build process.
See the code below in 's1ap-build.c' for where the crash occurs.
ogs_list_for_each(&mme_ue->sess_list, sess) {
ogs_list_for_each(&sess->bearer_list, bearer) {
...
if (mme_ue->nas_eps.type == MME_EPS_TYPE_ATTACH_REQUEST) {
} else if (OGS_FSM_CHECK(&bearer->sm, esm_state_inactive)) {
ogs_warn("No active EPS bearer [%d]", bearer->ebi);
ogs_warn(" IMSI[%s] NAS-EPS Type[%d] "
"ENB_UE_S1AP_ID[%d] MME_UE_S1AP_ID[%d]",
mme_ue->imsi_bcd, mme_ue->nas_eps.type,
enb_ue->enb_ue_s1ap_id, enb_ue->mme_ue_s1ap_id);
continue;
}
...
}
}
- Set the number of UEs in units of AMF/MME instead of gNB/eNB.
- See default value as shown below
Number of UEs per AMF/MME : 4,096
Number of gNB/eNB per AMF/MME : 32
