Make sure the sccp_cc_timeout is stopped when we delete the
associated data. There is one crash report that indicates that
we have a pending timer that is inside freed memory.
A crash could have occured when the connection to the MSC was
lost while have unconfirmed connections.
We do want to send PING/PONG in both ways to have a heartbeat
on the TCP connection. When switching over to SCTP we can rely
on the builtin heartbeat functionality.
We will send a ping every 20 seconds and if we have no pong
within 5 seconds we will close down the BSC connection and
wait for a reconnect. We will start this after having
authenticated the BSC and we stop the timer when destructing
the BSC connection.
The code needs to be refactored but this is fixing the leak for
now. We used to forward everything to the BSC but now we handle
the DLCX locally and this means we need to clear the patched
message. We should refactor it to not generate the patched msg
until a lot later.
I assume the original code crashed with a double free as we
have a cleanup at the end of the method. Return from the routine
like the case label below. This is fixing a memory leak I am
experimenting.
Stop using the global vty context for all allocations
and allow to embed the buffer into a given context, and
allocate sub buffers with the context of its parent.
Currently the nanoBTS bootstrap code requires a high delay
otherwise we are not bringing the device up properly. Changing
the init code turns out harder than it seems like. So this is
a workaround for that to allow a high speed RSL/OML connection
after the bringup.
The line driver can have a default TS delay. It is set to the
current default for the nanoBTS and the BS11. For the ipaccess
case we will set the delay lower for the RSL connection and
inside the ipaccess-config we can set it low right away to
have fast firmware flashing and such.
In case we can not find the SCCP connection we still want to
free any pending transaction ids and reset the BSC inside the
endpoint. In most cases this should be already done when the
SCCP connection or the whole BSC is gone.
When allowing to reallocate an allocated endpoint we will need
to free it first. When freeing we will free the call id and other
ids that we would have leaked otherwise.
Remember that we have seen a CC and have a valid destination
local reference now and only send a fake RLC to the MSC when
we had connections in this state.
For now close the connection when having a short read. This might
be due a network issue (loss of segment) or similiar. As we are not
handling these issues well, let us close the connection.
